dauntless Posted December 2, 2016 Posted December 2, 2016 An old chestnut this, I am in the throes of assembling an old Accurate Miniatures Avenger and I would like to know how the hell the turret fits inside the fuselage. Years ago there was a link to some instructions on the Accurate Miniatures Website but that has well gone now. Just asking as I don't fancy a cock up at this late stage, thanks in advance lads. Dauntless
Tbolt Posted December 2, 2016 Posted December 2, 2016 (edited) Here you go, courtesy of Google http://modelkitsreview.com/wp-content/uploads/2012/04/TBM-3D_0122.pdf Edited December 2, 2016 by Tbolt
dauntless Posted December 2, 2016 Author Posted December 2, 2016 Tbolt I feel a right chump! I couldn't find it when I googled it, note to self, must try harder, again many thanks. Dauntless
Seawinder Posted December 4, 2016 Posted December 4, 2016 It's all about tilting the turret, getting one side into the opening, then persuading the other side to clear the edge. When I built mine this past year, I wasn't sure it I'd be able to get it in with the rear canopy in place, so I left that off until later. As it turned out, I had to remove the turret for some reason after I had cemented the canopy piece -- no problem. Once you've got the turret completely into the opening, rotate it it so the guns are perpendicular to the fuselage and wiggle until the tab at the bottom seats itself in the slot. 1
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now