Search the Community
Showing results for tags '90S'.
-
Hi and welcome to the build thread for my third model. Its a Toyota Celica GT four 165. To be more precise i'm building the 1990 safari rally wining car sponsored by rep sol as a challenge to myself to improve the quality of both my decal work and white paint finishes. The kit is made by Aoshima /beemax and so far I have to say my initial impression is that there is lots of fine details and the quality of the mouldings appear to be top notch. I dry assembled a lot of the kit in two sections looking for any potential problems and apart from the roll cage being a potential pain in the neck if the c7r I built as my first project was anything to go by I could only find two areas which I predict could cause me a few headaches. The first is the suspension as I found it akward to line it up correctly however when I finally got it right it seemed like a matter of alignment. The other potential issue is some of the holes are a snug fit before I add paint in to the mix but again i think this wont be to bad of an issue. My current plan is to drill out any of the peg slots if I cant get the parts to fit correctly as a last resort. I am considering drilling out the brake disks with my new pin vice kit they wont be to visible should I goof it up and it will be good practice for when I build my next bike kit should I match the drill bit to the existing indents ? Would I be better of to do this before or after I have painted them in the base coat? Had I thought of it I would of taken some pictures of the sprews before I started but I didn't think to so here are some pictures of the parts I have primed so far. I have had my first covid jab today and its knocked me for six so i haven't been able to get as much done as i would like to have done.