Xtrakit SRA-1 3D decals problem

[Willie Heckaslike]

I recently bought an Xtrakit Saunders-Roe SRA-1 and found that the 3D decals were misaligned as the underlying print and the 3D outer were 1mm out of register. Just wondering if anyone has the same issue?

[mossieramm]

Currently at this building stage and I see no misalignement. The decals are larger than the plastic.

Pity the instructions dont mention the decals and where to put them

[John R]

I don't recall any problem when I built mine but then I am not too concerned about the inside of cockpits. In this case they are not visible if you build it with the canopy closed.

John