Eduard P-38J Lightning Seat PRINT (648811 for Tamiya) 1:48

[Mike]

P-38J Seat PRINT (648811 for Tamiya)

1:48 Eduard Brassin

 

 

Although this set arrives in a flat package, the directly 3D printed parts are safe inside a clear plastic clamshell box inside the package, which also has a sticky pad inside to prevent the parts from rattling about. The parts are printed resin, attached to the base via thin tendril-like fingers that are easy to cut off and sand the little upstands away, leaving them ready for action.

 

 

Consisting of just one crisply printed resin part, plus a small fret of nickel-plated pre-painted Photo-Etch (PE) STEEL that contains seatbelts plus comfort pad, the set should be a relatively straight forward replacement for the kit part, with the addition of substantial fine detail, plus the highly realistic seatbelts that should drape over the seats well thanks to the softer, thinner steel substrate.

 

Highly recommended.

 

 

Review sample courtesy of