Jump to content

Recommended Posts

Posted

AH-1G Cobra 3D Printed Acrylic Instrument Panel (RFSQS-32030 for ICM)

1:32 Red Fox Studio by AMMO

 

boxtop.jpg

 

During the last few years we have been blessed by the introduction of new technologies to our hobby, amongst them being 3D Printing in coloured resins to create instrument panels, dials and all sorts of interior (and exterior) details for our models in various scales.  New company (to us) Red Studio of Hungary have begun producing a range of these panels in various scales under the distribution of AMMO by Mig Jiménez, which broadens their introduction to the market appreciably.

 

Their sets arrive in clear foil bags with a red card topper for display on racking, held together by a single staple.  With the staple undone, the bag empties to unveil a folded card backing that also has the parts printed on its satin surface, a concertina folded instruction sheet, and the sheet of decals that face outward at the back.  The sheets are small, but the detail is exceptional, looking about as realistic as a panel can get at this scale.  The instructions lay out clearly where the parts should go, and the areas that will need their moulded-in detail removing are marked out in blue over photographs of the kit parts, which are also called out by sprue and part number for your ease.  The next step shows where the individual parts should fit, again arrowed to their location on the actual parts.

 

32020.jpg

 

This set includes two instrument panels, one for each for the crew, plus side-console panels for each of their cockpits, totalling five additional decals in all.  The rear pilot’s side consoles has two separate sections on the left and one on the right, all of which are superbly detailed, and should be attached to the kit parts via PVA or super glue.  From my experience, 1:32 lends itself very well to this type of decal, giving a balance of depth and detail at its most effective.

 

instructions.jpg

 

There are a number of notes made throughout the instructions advising you not to try to cut the decals with a scalpel as they could disintegrate due to their delicate nature.  They also tell you that you can apply most types of washes and varnishes over the surface once they are applied, and that once wet they are somewhat flexible, although there are limits of course, which is stated to be 5%.  The resins used in production are also ultra-violet (UV) resistant, so your dials and other light parts shouldn’t be affected over time, retaining the same look as if they had just been applied.  Here is a link to an instruction guide on how to apply this type of decal to your models, which should help you avoid any pitfalls.

 

 

Conclusion

The detail applied to 3D printed instrument panel is at the current apex of realism, and as such they’re one of my must-have choices of aftermarket for the discerning modeller.

 

Very highly recommended.

 

bin.jpg

 

Review sample courtesy of

logo.png

 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...