Seawinder Posted October 6, 2022 Share Posted October 6, 2022 I'm finishing up the Airfix Mk. V trop and using the kit markings for "Buck" McNair's plane, Operation "Spotter," Malta early 1942. Can anybody tell me if it's likely the plane had the stabilizer-to-fuselage IFF wires installed? Thanks! Pip Link to comment Share on other sites More sharing options...
alt-92 Posted October 6, 2022 Share Posted October 6, 2022 Possible. 1 Link to comment Share on other sites More sharing options...
Seawinder Posted October 6, 2022 Author Share Posted October 6, 2022 Very helpful, thanks! The one photo I've seen of AB264 doesn't show the rear fuselage, but I think I'll put the wires on anyway. Link to comment Share on other sites More sharing options...
alt-92 Posted October 6, 2022 Share Posted October 6, 2022 You wouldn't be alone in adding them A guy I know did his with the wires. https://thescalemodelhangar.com/2018/04/24/spitfire-mk-vb-tropical-malta-defender/ Also has a pic (grainy, unfortunately) of AB264 3/4 front view while on Malta, but the detail is too coarse to distinguish. Link to comment Share on other sites More sharing options...
Hornet133 Posted October 6, 2022 Share Posted October 6, 2022 They would be there. Without IFF there is no way to tell if a radar contact approaching Malta is the enemy or some of your own aircraft returning. If that was the case they would have to scramble to meet every contact on the radar, which is a waste of effort and in particular fuel which they were very short of. Unless the light is at the correct angle we know the wires are almost impossible to see. They were eventually replaced by a short aerial under the wing but that was only from April 1943 (long after this period) and it took months to do the change over. 2 1 Link to comment Share on other sites More sharing options...
BS_w Posted October 7, 2022 Share Posted October 7, 2022 june 43 appear the new IFFs with antenna mast under the wing, but the old IFFs with cheese cutter antenna remain in place on the a/c already fitted. so after this date we can see the both type. Malta spitfire was a specific case an lettre dated 18th june 43 from Air Headquarters, Malta. to R.A.F Station LUQA R.A.F Station HAL FAR R.A.F Station TA KALI R.A.F Station KRENDI R.A.F Station SAFI Maintenance wing Malta Spitfire aircrafts - removal of I.F.F. Gear. Certain Spitfire aircdraft have had the I.F.F. removed in accordance with Spitfire Local Modification No.4. This modification when embodied, called for the removal of inertial balance weight introduced by modification Spitfire/370. 2. Recent Mediterranean Air Command Instructions ordered the replacement of IFF gear in these Spitfire aircraft.... ..... for these reasons the cheese cutter aerial was not always visible on the pics of Malta Spitfire. Link to comment Share on other sites More sharing options...
ilj Posted October 7, 2022 Share Posted October 7, 2022 Spitfire Vc BP989 N-4 Wally McLeod RCAF 603 squadron Takali 9 July 1942... I included IFF antenna cables made with Uschi extra fine thread 1 Link to comment Share on other sites More sharing options...
Tail-Dragon Posted October 7, 2022 Share Posted October 7, 2022 I also included it on my 'Buck' McNair Vb. While there is no photo evidence of it on that airframe, there is plenty of photos that show it on other contemporary Malta aircraft. 2 Link to comment Share on other sites More sharing options...
MACALAIN Posted October 9, 2022 Share Posted October 9, 2022 On 06/10/2022 at 21:21, Seawinder said: I'm finishing up the Airfix Mk. V trop and using the kit markings for "Buck" McNair's plane, Operation "Spotter," Malta early 1942. Can anybody tell me if it's likely the plane had the stabilizer-to-fuselage IFF wires installed? Thanks! Pip No IFF wire for me. Alain Link to comment Share on other sites More sharing options...
Graham Boak Posted October 9, 2022 Share Posted October 9, 2022 The IFF aerial was a vital fit for the gruund control. As there is an instruction for Malta to remove it in 1943, the obvious conclusion is that it was present before then - as shown in the photographs. However, in small scales adding it is a pain. Link to comment Share on other sites More sharing options...
Seawinder Posted October 9, 2022 Author Share Posted October 9, 2022 I've got the holes drilled to add them. No big problem in 1/48. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now