F4F Seat PRINT (672291 for Arma Hobby) 1:72

[Mike]

F4F Seat PRINT (672291 for Arma Hobby)

1:72 Eduard Brassin

 

 

Although this set arrives in a flat package, the directly 3D printed parts are safe inside a clear plastic clamshell box inside the package, which also has a sticky pad inside to prevent the parts from rattling about. This set has onew printed resin seat on its own print platform, with the parts attached to the base via thin tendril-like fingers that are easy to cut off and sand the little upstands away, leaving the parts ready for action.  There is also a small fret of STEEL Photo-Etch (PE) that are also pre-printed with seatbelt parts, which includes four belts and a single comfort-pad for underneath the buckle.

 

 

Once removed from the print-base, the seat is a drop-in replacement, and after painting it should be draped with the seatbelts, the shoulder straps in a single Y-shape that is folded over the rear of the seat-back, while the lap belts are attached to the sides of the seat and folded over as if the pilot has just left his cockpit.  Detail is fabulous as you’d imagine from 3D Printed resin and PE, which should be easy enough to add some extra detail to your Arma Wildcat.

 

Highly recommended.

 

 

Review sample courtesy of