Dummy bolt and screw heads, nuts for 1/20?

[Peter Browne]

What do you use for dummy bolt and screw heads, nuts?  I'm looking at 1/20 for MFH.  Metal is preferred.

[David M]

G'day Peter,

Several sources:

RB Motion (all metal (aluminium), wide range, excellent products and service and Rob Bentley is a good guy. Postage from US to Oz can be expensive)

Top Studio (all metal (some steel, some brass, some aluminium), massive range, fairly widely available both here in Oz and from the usual outlets in Asia i.e. HobbyEasy, HobbySearch, etc))

Hobby Design (as for Top studio)

Tuner Model Manufactory (aka TMM or T2M, long out of production but occasionally remnants pop up on Evilbay or Yahoo Japan)

All four have nuts, bolts, screws, etc and AN fittings for hoses, etc.

PM me if you have any difficulties.

David M

[Ade H]

@Peter Browne Hello, Peter.

Try Tom Anyz at anyz.io. At the bottom of the page in the resin section, you should find Nuts & Washers Type 1 (AN018) and Type 2 (AN019) which may suit your needs.

Edited October 11, 2021 by Ade H
typo

[Pete in Lincs]

Or follow this link to Amazon for Meng nuts and bolt ends (meant for 1/35th) but in various sizes for just 3.99

https://www.amazon.co.uk/MENG-Scale-Model-Nuts-Bolts/dp/B00DUQ7S92/ref=sr_1_8?dchild=1&keywords=meng+nuts+and+bolts&qid=1633970630&sr=8-8

[Bozothenutter]

And there is Masterclub.

Ostensibly for 1/35, but a hex is a hex....