FrankJ Posted August 27, 2021 Share Posted August 27, 2021 I don't know about South of the border but apparently a new ruling on smoke/heat alarms comes into force in Scotland February 2022. Interlinked alarms to be fitted in houses, not just new builds. Wondering if anyone has them fitted in the same room/workstation where you build & paint your models where there maybe lots of paint, thinners & other chemicals are stored. Link to comment Share on other sites More sharing options...
Duncan B Posted August 27, 2021 Share Posted August 27, 2021 One of mine is fitted on the landing right outside my modelling room and I've never had any problems with it being set off by my hobby stuff. I know they are sensitive though because a farmer 2 miles upwind of us was burning some stuff and the smoke from that was setting the alarms off! Duncan B Link to comment Share on other sites More sharing options...
bentwaters81tfw Posted August 27, 2021 Share Posted August 27, 2021 10 minutes ago, Duncan B said: One of mine is fitted on the landing right outside my modelling room and I've never had any problems with it being set off by my hobby stuff. Duncan B Likewise. 1 Link to comment Share on other sites More sharing options...
davecov Posted August 27, 2021 Share Posted August 27, 2021 As above. My landing smoke alarm is 18" from my modelling den door that cannot close properly. In 12 years despite my best efforts at air pollution caused by my modelling, I have never set the alarm off. Burnt toast downstairs is a different matter! Dave Link to comment Share on other sites More sharing options...
ckw Posted August 27, 2021 Share Posted August 27, 2021 I have one in my modelling room - nearly directly above the spray booth. With all the nasties in this room, I want the earliest possible warning! It's never gone off (just tested it to make sure it's actually working ) Cheers Colin Link to comment Share on other sites More sharing options...
RobL Posted August 27, 2021 Share Posted August 27, 2021 (edited) Unless paint and thinners start spontaneously combusting (which they don't), I would imagine everyone's going to be alright. Unless they leave their stuff near a naked flame or something electrical, and faulty, plugged in when they're not around... The trick is not to spray smoke around... Edited August 27, 2021 by RobL Link to comment Share on other sites More sharing options...
JohnT Posted August 27, 2021 Share Posted August 27, 2021 My understanding- no doubt imperfect as usual - is that the monitors are checking for particles in the air from smoke. So normal modelling shouldn’t set them off. If spraying or working with resin there are other health issues though Its still a good idea to upgrade or install from new Also landlords letting out property have to have them interlinked and hardwired in to stop tenants removing batteries ! 1 Link to comment Share on other sites More sharing options...
Julien Posted August 28, 2021 Share Posted August 28, 2021 1 2 Link to comment Share on other sites More sharing options...
3DStewart Posted September 1, 2021 Share Posted September 1, 2021 (edited) On 8/28/2021 at 5:15 PM, Julien said: This link doesn't work. Regards the original post, I found this: "The new standard applies to all homes . . . It will be the property owner’s responsibility to meet the new standard, however, the legal duty to enforce the standard rests with local authorities. Where owners are unable to meet the standard, it is not a criminal offence." That sounds to me like a laborious job for councils, so it wouldn't surprise me if there's low compliance for a long time. Edited September 1, 2021 by 3DStewart Extra info. Link to comment Share on other sites More sharing options...
spitfire Posted September 2, 2021 Share Posted September 2, 2021 Sounds like it will be a very expensive change for a lot of people, with the number of buildings requiring changes electricians and alarm retailers will be quids in. Cheers Dennis 1 Link to comment Share on other sites More sharing options...
Duncan B Posted September 2, 2021 Share Posted September 2, 2021 On 9/1/2021 at 2:40 PM, 3DStewart said: This link doesn't work. Regards the original post, I found this: "The new standard applies to all homes . . . It will be the property owner’s responsibility to meet the new standard, however, the legal duty to enforce the standard rests with local authorities. Where owners are unable to meet the standard, it is not a criminal offence." That sounds to me like a laborious job for councils, so it wouldn't surprise me if there's low compliance for a long time. In all likelihood in most domestic properties they won't get changed until the originals need replacing or until the property goes up for sale as it'll be flagged up on the home report. I changed mine out a couple of years ago so won't be changing them again before February unless someone else is paying! I have no problem with meeting the new standard when the time comes to change them out as it seems like a reasonable standard to set. Duncan B Link to comment Share on other sites More sharing options...
Tim R-T-C Posted September 2, 2021 Share Posted September 2, 2021 I didn't realise you can get interlinked wireless alarms, makes sense really and can be installed without any wiring needed. Had a quick look on Amazon and no-one is currently offering a 'Scottish box' with the minimum mandated three smoke, a heat and CO alarm, but I suspect these will be available pretty soon. Link to comment Share on other sites More sharing options...
Mick4350 Posted September 3, 2021 Share Posted September 3, 2021 I've an interconnected smoke alarm in my bedroom and kitchen area. Was installed by landlords free of charge. Previous one was hardwired into the ceiling of my unit, which is a 10 inch concrete slab. The tenants above me sound like fairy elephants at times 🤝 Link to comment Share on other sites More sharing options...
Mike Posted September 17, 2021 Share Posted September 17, 2021 When they say "interconnected" does that include the Google Nest smoke/carbon monoxide alarms? Not cheap, but they'd do for an existing property because you don't need any wires. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now