Jump to content

Sd.Kfz.171 Panther Ausf.A Early Zimmerit Decal (SPS-077) 1:35


Mike

Recommended Posts

Sd.Kfz.171 Panther Ausf.A Early Zimmerit Decal (SPS-077)

1:35 Meng via Creative Models Ltd

 

boxtop.jpg

 

If you're not sure what Zimmerit was, it was an anti-magnetic coating applied to the exterior of German AFVs from the end of 1943 to the 9th September 1944 in the factories and a little later in the field.  It took the form of a thick fibrous paste with a greyish hue, and the application was usually ridged to give it a larger effective thickness without adding too much weight.  It was water-based and applied to all vertical or near vertical surfaces over primer with a comb-like tool or stamp, and drying was then accelerated by using blow-torches over the application.  There were a number of patterns used at certain factories, so it can be a minefield debating whether the vehicle had Zimmerit, which pattern it was, and how you would apply your own rendition to your model.

 

Originally you were left to your own devices to use putty and a screw-driver tip, or later-on Photo-Etch (PE) sheets, which was a little regimented and inflexible.  Now with the advances in decal technology, Meng and a few others have begun creating 3D decals that when applied give the appearance of this rough coating.  The sheet arrives in thick plastic bag with a card header, a sheet of visual instructions and a sheet of Zimmerit decal protected by a thick piece of waxy paper.  The instructions are simple diagrams showing where each part fits on the hull and turret, including such niceties as shaped parts for the mantlet, kugelblende and even the area under the side-skirts where a brave (foolhardy) man could slap a magnetic shaped-charge.  A small note at the bottom in three languages indicates that if any edges begin to peel away from your model, you can re-glue them with super-glue (CA) or modelling glue.  The decals are even printed in a similar grey shade to the real thing, so chipping a little paint could be used to depict exposed Zimmerit.

 

sheet1.jpg

 

detail.jpg

 

This set is patterned for their newly released kit that you can see our review of here, which will be of use for any of the four decal options included with the kit, sold separately to give the modeller the option of either not bothering, doing it yourself, or adding these decals to your shopping cart.  The pattern for this set is reminiscent of an oversized waffle-pattern, consisting of large roughly applied squares with small gaps between each one, and the distinct impression that they have been applied by hand, possibly by someone in a rush or who didn’t care about it being too tidy.  That’s likely to be the case, as slave labour was commonly used in German WWII factories, particularly during the period that Zimmerit was being applied, and if they weren’t slaves they would have been employees under the cosh from management to keep the production-line moving quickly, as these tanks already took far too long to complete when compared to Shermans or T-34s.

 

Conclusion

You can of course apply Zimmerit yourself using whichever of the other techniques that you prefer, but this is likely to be the quickest and easiest method that should also be the most realistic once painted and weathered.  It will also be easy to chip and abrade away to give the impression of a careworn coating.  It also helps that it’s quite reasonably priced.

 

Very highly recommended.

 

bin.jpg

 

Review sample courtesy of

logo.gif

  • Thanks 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...