dnl42 Posted September 19, 2021 Share Posted September 19, 2021 First off, those are some amazingly clean cuts! And, thank you for those full-scale photos. My brain was just getting too fried... 1 Link to comment Share on other sites More sharing options...
Camwader Posted September 19, 2021 Author Share Posted September 19, 2021 (edited) 5 hours ago, ArnoldAmbrose said: Gidday Camwader, OK, you've convinced me. That ultra clean workshop should have been a giveaway. You need some 1/12 scale dirt on the floor. 😁 Seriously, you've done a good job on the bow and stern of the canoe (which is which?). That whole scene is a work of art, all it needs is a pin-up calendar (you know the sort 😁) Very well done. Regards, Jeff. Arnold, The 1/12th garage is really just a WIP in its very early stages - it needs a lot more work. These pics are from my 1/6th garage - I know what needs doing, I just haven't got around to it yet, too many other projects on the go. The canoe is symetrical end to end, the only thing that dictates which end is which is where the seats are positioned. When paddled two-up it goes one way, when paddled solo it goes the other way. Edited September 19, 2021 by Camwader 3 Link to comment Share on other sites More sharing options...
dnl42 Posted September 19, 2021 Share Posted September 19, 2021 6 hours ago, Camwader said: These pics are from my 1/6th garage - OK, you're doing it to use again. Link to comment Share on other sites More sharing options...
Camwader Posted September 19, 2021 Author Share Posted September 19, 2021 43 minutes ago, dnl42 said: OK, you're doing it to use again. dnl42, My first post on Britmodeller in April 2018, posted in finished Dioramas, was all about my 1/6 garage. I was going to put a link in to that post, but the photos there don't seem to be loading very well, so if you want to seem more - have a look at my Flickr album: Camwader's Garage Link to comment Share on other sites More sharing options...
Camwader Posted September 29, 2021 Author Share Posted September 29, 2021 A little more progress - scuppers and inwales going in, just leaves the outwales and seats to fit. I reckon the next post should be 'Ready for Inspection'. 5 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now