Jump to content

Recreating oil-canning technique.


LooseSeal
 Share

Recommended Posts

Hi guys,

 

I'm just about to start on the HK Models 1/48 Lancaster and could use the expertise of those much more experienced than I! While the kit is absolutely superb in its detail, the one thing I find lacking is the distinctive 'oil-canning' of the panels.

 

So, I was wondering about how to recreate this and was thinking of using Mr Surfacer 500 to raise some panels, and the engraving tool on my Dremel to recess a smaller number. Does that seem like something that could work? Has anyone attempted something similar? Or am I potentially just going to waste many hours on something that may look a little silly in the end? As if I've never done that with a model before... 😄

 

Any feedback on the idea welcome, or alternative suggestions! Thanks!

 

 

Link to comment
Share on other sites

This chap has done some on the larger HK Lancaster and might be a useful insight

 

http://www.hyperscale.com/2020/galleries/lancasterhkmodels32ls_1.htm

 

I have attempted myself with selective masking and PAINT . . . not to obvious but then it shouldn't be  .  . . 

 

  • Like 2
Link to comment
Share on other sites

Hmm.. he used the 1200 Mr Surfacer instead, perhaps I'll try a less coarse one then, especially as it's a smaller scale.

 

Thanks for the link! I'm going to do one wing lower wing surface first and see how it looks. At least with Mr Surfacer you can just wipe it off with alcohol thinner if it doesn't work.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...