Dynavector 1/48 Douglas A2D-1 Skyshark- The Skyraiders "Younger Brother"Finished

[LorenSharp]

Down to the final fine points. Spent the day going crossed applying The stenciling. Nice fine printed white stencils printed on an equally light coloured sheet.  At times I had to guess even with a lighted magnifying lamp where the carrier film was so I could trim from the paper. Ugh.

I did add the drop tanks and erred in drilling out too many holes for the ordinance. I just followed where the drill marks were. So I used some card stock and made a set of empty pylons and added the pitot tubes. I'll let this dry tonight and spray a gloss lacquer coat to seal everything up, add the rockets and give it a little bit of weathering. Frome there I do believe it will be ready for the RFI.

[LorenSharp]

After adding the final bits, rockets, anti-collision lights other stuff, I can now present you with the Skyraiders younger "little " brother...

And something for size comparison, sitting a P-51 alongside

[

It's been a interesting journey and surprisingly fast, But then this is a well produced vac. I don't think I'll be this luck on my next Vac build. It will be more . Thanks everyone for following along and giving comments and help along the way it's been much appreciated.

I will be posting more pictures in the RFI in a few so until next time Stay Safe, Stay healthy.

P.S. 

Here is the RFI