dov Posted February 5, 2021 Share Posted February 5, 2021 Hallo This is now my Fw-190 A-5 in 1/32 from Hasegawa. The plastic built was straightforward. A few flaws caused me wondering: · Wheel bay inner doors actuator position left unknown · The outer wing MG omitted · The fuselage MG holes are sloppy and awful defined · The engine parts, for gear and push rods are misleading due to 180° holes and pins · At the cockpit the cushioning on the right side is omitted It is no matter at all for me, but for a beginner it may cause a headache or a spoiled model. I just wonder about such an inadvertence. Now my model should become the black 7 from JG 54. I have original photos from this a/c and from this squadron too. So, the inner wheel well doors are on. All markings I will spray with Gunze C colors. All markings first with Montex masks. White base for yellow and marking in C316. Happy modelling 1 Link to comment Share on other sites More sharing options...
dov Posted February 7, 2021 Author Share Posted February 7, 2021 Some steps forward. After spraying one color, wet sanding with 6000+ to prevent edges! Happy modelling 1 Link to comment Share on other sites More sharing options...
dov Posted February 9, 2021 Author Share Posted February 9, 2021 Hallo The camo and insignia and markings are done. Now I took a 6000 pad and cleanrd the surface from color edges. Next time exhaust, tabs and weathering! Happy modelling 1 Link to comment Share on other sites More sharing options...
mick Posted February 9, 2021 Share Posted February 9, 2021 great camo work Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now