Evil_Toast_RSA Posted January 17, 2021 Share Posted January 17, 2021 As title. I'm planning on bringing my old Badger 200 back into service for priming duties, stuck in the Medium needle and air cap from my Badger 100 (is interchangeable) and gave it a quick spray (~20 psi) with some water to see if their was any problems, using the metal colour cup, and the water "spray" started pulsing. My 100 doesn't do this, checked immediately afterwards. Also run off a reservoir tank, so it's not an air flow problem. Not going to lie, a bit confused. Any suggestions? I gave the 200 a proper clean before packing it away a year ago, but will give it another clean today sometime. Link to comment Share on other sites More sharing options...
Evil_Toast_RSA Posted January 17, 2021 Author Share Posted January 17, 2021 Well, after a good soak in laquer/cellulose thinners, seems to work just like I remember it. Didn't see any gunk come out, so whilst still confused, not all that concerned anymore. Maybe a bit of dried paint blocking an air channel or the air valve was a bit loose/jammed/temperamental? Still open to ideas in case this comes up again or is a sign that my 20 year old airbrush needs to retire. Link to comment Share on other sites More sharing options...
Railfan87 Posted February 28, 2021 Share Posted February 28, 2021 (edited) I have an old Badger 200 as well. The only time I've ever had it, or any airbrush, pulse is if the tip isn't as tight as it should be. Is it possible when you stripped and reassembled it, you put the tip in tighter? They're a simple and reliable tool. Not much to them to go wrong. Chris Edited February 28, 2021 by Railfan87 Link to comment Share on other sites More sharing options...
Rob de Bie Posted September 19, 2021 Share Posted September 19, 2021 In my experience, this problem is caused by a leaky teflon seal inside in the main body. It allows air through, and they come out the front as air bubbles. The alternating of paint and air causes the pulsing you experienced. Rob Link to comment Share on other sites More sharing options...
Steve Noble Posted November 18, 2021 Share Posted November 18, 2021 As above teflon seal inside the main body. I got rid of mine as I was sick of replacing it.. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now