moaning dolphin Posted October 23, 2020 Share Posted October 23, 2020 Greetings knowledge hub! I have a bizarre request. I've got a 1:35 Super Frelon and the instrument panel is horribly bare. I have seen a 1:35 Eduard etch fret for a Chinook and i think i could make use if the parts of that fret but i dont want to invest $20 and find out its too small or too big. So if you have the kit could you measure the height and width if the face of the instrument panel please. If you have the actual etch parts the size of the panel on there would be more than helpful. Many thanks in advance! Bob Link to comment Share on other sites More sharing options...
Wafu Posted October 24, 2020 Share Posted October 24, 2020 I’ll get back to you shipper’s. 1 Link to comment Share on other sites More sharing options...
Wafu Posted October 24, 2020 Share Posted October 24, 2020 Hello Bob, the etch fret for the CH-47 is 49mm wide and 12mm high. Hope this helps? 1 Link to comment Share on other sites More sharing options...
moaning dolphin Posted October 24, 2020 Author Share Posted October 24, 2020 1 hour ago, Wafu said: Hello Bob, the etch fret for the CH-47 is 49mm wide and 12mm high. Hope this helps? Thanks for that, very much appreciated. It does help, unfortunately only in saving me 20 bucks 😄 its about 10mm too wide, so back to the drawing board. Many thanks once again! Bob Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now