Shar2 Posted March 18, 2020 Share Posted March 18, 2020 (edited) Although I actually started this a week or so ago I've only now thought about doing a WIP. As it is, I spent most of this time filling and sanding, particularly the large section of the lower bow which was short shot. Edited March 18, 2020 by Shar2 6 Link to comment Share on other sites More sharing options...
Arjan Posted March 19, 2020 Share Posted March 19, 2020 That's a promising start ! Don't know how accurate you wish to make your model but the door of the bow gun tub should be at the rear and not at the side. This is quite easy to remedy, at least if you haven't glued the fore deck yet (simply remove the tub and give it a quarter turn). The diameter of the opening in the fore deck is also too small. A pic of my own S-100 build to illustrate my remarks : By the way, I like the paint job on the Vosper MTB (MTB 297 ?) Regards, Arjan 1 Link to comment Share on other sites More sharing options...
Shar2 Posted March 20, 2020 Author Share Posted March 20, 2020 Thanks for the tip Arjan will try and sort it, but the large lug in the tub only allowed one to fit it with the door to the side. Meanwhile, I've been hacking and slashing the engine deck, replacing all the plastic hatches with brass ones. still have some tidying up to do but they're looking ok. Also found a good place for the honey Jack Daniels while I do some modelling. 4 Link to comment Share on other sites More sharing options...
Modelholic Posted March 20, 2020 Share Posted March 20, 2020 Not keen on the honey JD but an excellent position for it. Tom Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now