Jump to content

As a result of the close-down of the UK by the British Government last night, we have made all the Buy/Sell areas read-only until we open back up again, so please have a look at the announcement linked here.

This site uses cookies! Learn More

This site uses cookies!

You can find a list of those cookies here: mysite.com/cookies

By continuing to use this site, you agree to allow us to store cookies on your computer. :)


Studio Scale UFO Interceptor

Recommended Posts

On mine I superglued some thick plastic card tabs along the lower join so they protruded by about 5mm and where about a centimetre apart.

I then started to glue the two halves together starting at one side and going slowly around the join, waiting for each tab to set, before gluing the next one.

When you get to the overlap, you just need to glue one tab at a time, applying pressure until the glue sets.

If you use Epoxy glue, or car body repair filler to fill the gaps, it will add strength and should keep the join solid.

There will be a lot of sanding! :)


Share this post

Link to post
Share on other sites

Fill with resin. Sand. Repeat ad infunitum.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...