Jump to content

Spitfire Mk. VIII - 1:72 Eduard ProfiPACK Edition


Julien

Recommended Posts

Spitfire Mk. VIII

1:72 Eduard ProfiPACK Edition

 

s1.JPG

 

More than any other aircraft - at least on this side of the Atlantic - the Supermarine Spitfire has attained legendary status. The type's role in the Battle of Britain, combined with its enduring presence at air shows, have combined to ensure the Spitfire is the one combat aircraft pretty much everyone can identify. One of the ultimate Merlin powered variants was the Mk. VIII. The Mk. VIII was intended to be the next major production variant after the Spitfire Mk. V, but the Mk. IX, intended to be an interim design while the Mk. VIII was being readied, proved to be up to the job. Nevertheless, it was the third most numerous variant after the Mk. IX and Mk. V although it served exclusively overseas. Supermarine's chief test pilot, Jeffrey Quill, considered the Mk. VIII the best Spitfire from a flying perspective but was scathing of the extended wingtip fitted to some early Mk. VIIIs, insisting that it did nothing other than reduce the rate of roll. 

 

 

 

The Kit

Eduard's range of small scale Spitfires are typical of their recent output: exquisite detail and superb – if complex – engineering which puts them right at the pinnacle of modern kit manufacturing. This Weekend Edition of their Spitfire Mk. VIII joins the Mk. IX and Mk. XVI in replicating the 1:48 scale range of Spitfires that were released a few years ago.  The quality of the mouldings is up to the usual Eduard standard, with clean, crisp details and no flaws anywhere. As with other recent kits from Eduard, there is plenty of fine detail, with parts such as the cockpit comparable to high-end resin items (which, in turn, should tell you how good Eduard's resin cockpit is). The surface detail on the outside of the airframe is exquisitely rendered, with fine recessed panel lines and delicately engraved rivet and fastener detail.

 

s2.JPG

 

s3.JPG

 

Eduard take an uncompromising approach when it comes to detail, resulting in a cockpit that is extremely well detailed. The pilot's seat is made up from three parts, while the cockpit sidewalls have been moulded separately in order to maximise the amount of detail they have been able to pack in. Once the cockpit has been assembled and painted, it can be fitted between the vertically split fuselage halves, along with the engine firewall, a blank part into which the propeller is fitted later on, and the pilot's head armour.

 

s4.JPG


 
The breakdown of the wing is no less complex. As you might expect, the lower wing has been moulded as a single span, with separate upper wing surfaces. Between the two you must sandwich seven parts which together make up the walls of the main landing gear bay. The ailerons and wing tips have been moulded separately, which allows for the extended wing tip fitted to some early Mk. VIIIs to be used (one of the decal options has the extended wing tips). The same applies to the rudder and elevators. Multiple alternatives are included on the sprues, so make sure you use the correct version for your intended subject. The upper and lower cowlings are moulded separately, with the former split along the middle. Even the wing radiators are made up of six parts each, with the surface of the radiators themselves picked out in photo etched metal in this boxing. 

 

s5.JPG

 

Turning the model over, the undercarriage is just as detailed as the rest of the kit. Each of the main landing gear legs is made up of seven parts, with the tyres moulded separately to the hubs and photo etched parts to represent hub covers (where fitted). The separate tyres will make painting easier and the wing cannon barrels are moulded separately, which means they can be added at the end of the build in order to avoid accidental damage. The transparent parts are nice and clear, and of course the canopy can be finished in open or closed position as you wish.

 

s6.JPG

 

s7.JPG

 

 

Decals
Decals are in house from Eduard and should pose no issues. There is a main sheet and a supplemental sheet for the stencils, markings are provided for a generous 6 examples;

 

  • JF330, flown by AVM Harry Broadhurst, 1943
  • MD280, flown by F/Lt. Paul Ostrander, No. 155 Squadron RAF, Burma, 1945
  • HF Mk.VIII, flown by W/C Robert Gibbes, CO of No. 80 Fighter Wing, Dutch East Indies, 1945
  • MT714, flown by F/Lt A. W. Guest, No. 43 Squadron RAF, Ramatuelle Airfield, France, August 1944
  • JF470, 308th Fighter Squadron , 31st Fighter Group, , Fano Air Base, Italy, 1944 – 1945
  • MT560, flown by Lt. Antony Brooke Woodley, No. 145 Squadron, Bellaria – Igea Marina, Italy, March 1945

 

s8.JPG

s9.JPG

 

 

Conclusion
This is a welcome new release from Eduard in a ProfiPACK box. Highly recommended.

 

 bin.jpg

 

     

Review sample courtesy of

logo.gif

  • Like 4
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...