Neko-Works Mustang GT350 ( Toon )

[ScanmanDan]

Just a little distraction from Japan

 

A solid resin character (toon) model of a Mustang.  Pretty clean from the package I have done a little trimming, sanding and some primer before two coats of colour.  I think I might just do one more coat of colour and then set it aside to dry out before a light sand/polish and some details.  There are a large range of models in the Neko-Works range but sadly only a few on offer at any one time.  Not a bad little squirrel though 

 

 

 

We'll see if I don't stuff it in painting the details.

 

 

Dan

[Pete in Lincs]

Only slightly bonkers then?

Nice paint finish.

[ScanmanDan]

Pete - No completely bonkers   

 

I'm pleased you like the yellow.

 

 

Progress;

 

Little bit of paint, still very rough and working through what works.  Next one will get a lot more pre paint prep and that would make detail painting a lot easier. 

 

Looks a little worse for wear but here goes.

 

 

 

Lots of little bits to tidy up but I'm getting the whoopsies so I'm going to go and do something else for a bit.  I think I can get her back to a presentable shape.  Need to make a little base too.

 

Thanks for looking in.

 

Dan

[Corsairfoxfouruncle]

Other than being a bit compressed and bubble shaped its actually surprisingly accurate. 

[ScanmanDan]

I've been messing about with this for the last few days, almost finished with the detail painting.  Thought I'd make a little base for the Mustang.

 

Here's what I came up with.

 

 

 

 

 

Experimented with a few things but good old 240 grit sandpaper painted up looked the best to my eye.  Just a bit more work and this one will be done.

 

Thanks for looking in.

 

Dan