Problems with microscale decal film

[James G]

Hi All,

 

I've had some problems using Microscale decal film on inkjet printed decals (on Experts Choice decal paper)...gave the decals a coat of decal film about 20 mins after printing and they have cracked up. I applied them using Microset and some of the colour has bled out. I've never had such problems before...the possibilities for what could have gone wrong are as follows:

1) I did not leave enough time between the printing and the first coat of decal film;

2) The first coat was too heavy; or

3) The decal film has 'gone off' (does it require shaking beforehand?)

 

Any tips?

 

Thanks,

 

James

[lasermonkey]

I've always left the ink to dry overnight before coating with Liquid Decal Film. I also apply two coats, just to be sure.

 I have found that the colour can bleed if you soak the decals for too long. Best to get the, in place as quick as possible.

[James G]

Thanks for the tips mate!

[TheRealMrEd]

Hi James,

 

I found that by using the Ink Dry powder to absorb extra ink immediately after printing, and the clear, flexible topcoat sealer (spray can), my Epson-printed decals came out perfectly, from Papilion.com.

 

Ed

 

(I have no conections with...yada...yada...yada)