albymoore Posted January 29, 2017 Share Posted January 29, 2017 Hi All Here is my recently completed Revell U-wing transport from 'Rogue One'. This ship is in my top 5 favorite Star Wars ships (the Republic Gunship, aka LAAT/i, is my favorite all-time) as I have thing for helicopter gunships like the Vietnam War era Huey in the real world. The same individual who 3D-milled the center drive section for my AT-ACT also milled the replacement engine nozzles and rear radiator panel for this kit as it was missing altogether (Revell received the U-wing profiles/plans for production from Lucasfilm before the ship's design was finalized for the movie). Instead of doing a total repaint, I concentrated on the areas around the seams and just touched those spots up after filling them in. The markings on the fuselage were distressed with a sanding stick or hobby knife (except the gray panel on the right side- it was airbrushed over some sprinkled salt for the chipping effect). The entire ship then received a pastel chalk wash. A little heavier than I intended, especially around the engines, so we'll just chalk it up to heavy interstellar abuse. Thanks for looking. Cheers, Albert 16 Link to comment Share on other sites More sharing options...
Hunter Rose Posted January 29, 2017 Share Posted January 29, 2017 Very nice! Lovely weathering and finish 1 Link to comment Share on other sites More sharing options...
Madhatter Posted January 29, 2017 Share Posted January 29, 2017 oh that's nice Albert! I like it a lot. The paint work and finish is amazing - I especially like the mottled finish you got on the bottom. How did you get that? Is that a green LED inside the cabin I spy at the end there? Really great stuff Si 2 Link to comment Share on other sites More sharing options...
albymoore Posted January 29, 2017 Author Share Posted January 29, 2017 5 minutes ago, Madhatter said: oh that's nice Albert! I like it a lot. The paint work and finish is amazing - I especially like the mottled finish you got on the bottom. How did you get that? Is that a green LED inside the cabin I spy at the end there? Really great stuff Si Thanks for complements, Madhatter and Hunter Rose! @Madhatter-The light in the cockpit is part of the light/sound module that's included with the kit (it's one of those snap-tite build & play kits marketed for kids). The weathered look on the lower surface was achieved by sprinkling salt over the pre-painted plastic and then airbrushing Vallejo Model Air Barley Grey over that (the Barley Grey is just a shade lighter, so the contrast would be subtle yet noticable). After everything dried, the salt was removed using a stiff brush and the pastel wash blended everything together. Thanks again! Cheers, Albert 1 Link to comment Share on other sites More sharing options...
Dermo245 Posted January 29, 2017 Share Posted January 29, 2017 Looks terrific, love the weathering. Dermot 1 Link to comment Share on other sites More sharing options...
noelbarnes Posted January 30, 2017 Share Posted January 30, 2017 That look terrific. Nicely weathered too.....looks very real. 1 Link to comment Share on other sites More sharing options...
albymoore Posted January 30, 2017 Author Share Posted January 30, 2017 Thank you, Noel and Dermot! Link to comment Share on other sites More sharing options...
Romeo Alpha Yankee Posted January 30, 2017 Share Posted January 30, 2017 Another nice job Albert, does this kit allow the wings to swing? Link to comment Share on other sites More sharing options...
albymoore Posted January 30, 2017 Author Share Posted January 30, 2017 44 minutes ago, TrojanThunder said: Another nice job Albert, does this kit allow the wings to swing? Thanks, Ray! Yes, the wings do swing. Mine are glued in the forward position though as they rattle a bit due to their length and rather tight fit around the mounts at the rear of the fuselage (this causes the wings to seat slightly higher at the forward fuselage area, thus the rattling at that section). Cheers, Albert Link to comment Share on other sites More sharing options...
Mark4700 Posted January 31, 2017 Share Posted January 31, 2017 Excellent build. Weathering is spot on. Link to comment Share on other sites More sharing options...
R0ver Posted February 1, 2017 Share Posted February 1, 2017 Looks great! Love the weathering, especially around the engines at the back. Looks like it's just managed to escaped from an obliterated Jedha. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now