Atlas Cheetah - Possibility from Wingman Kits ?

[Tiger331]

Does anyone know if it is possible to produce any of the Atlas Cheetah variants from the plethora of Wingman kits for the Kfir and Mirage 5 ?. By my reckoning it should be possible to mix and match plastic and resin parts from the two 'sub-species' to produce one but I just wondered if anyone has already tried it or has more subject matter expertise than I ?

Thanks

Mark

[Selwyn]

Does anyone know if it is possible to produce any of the Atlas Cheetah variants from the plethora of Wingman kits for the Kfir and Mirage 5 ?. By my reckoning it should be possible to mix and match plastic and resin parts from the two 'sub-species' to produce one but I just wondered if anyone has already tried it or has more subject matter expertise than I ?

Thanks

Mark

you would probably better off with one of the cheetah kits by high planes models.

Selwyn

[Vlamgat9]

There are no High Planes Cheetah kits in 1/48.

John at Scaleworx is retooling his Cheetah conversions to fit the a Kinetic Kfir. The E is already available.

[exdraken]

the Cheetah C has a longer fuselage behind the cockpit, and different chaff/flare dispensers on the under-fuselage faring.

apart from that , I think you could try to match Wingman Kfir C10 forward fuselage with any/ Kinetics Mirage kit!.

you could probably do something similar with WIngman's 2-seater Kfir forward fuselage and mate it with Kinetic's MIrage kit to get a Cheetah D

or wait for the scaleworxx conversion. till now Scaleworxx was very to get....

Edited December 27, 2015 by exdraken