Jump to content

Minicraft 1/144 Spitfire V - Completed


Recommended Posts

I did think those where going to be your famous last words Speedman! I've built a few minicraft kits and they where all shocking and cheap, might explain a lot actually. Will be seeing how you progress with this one :)

Kind Regards

Dazz

Link to comment
Share on other sites

I take it back... It's awful.

Yeah that's pretty bad. I didn't find the Revell 1/144 Mk1 Spitfire too bad apart from the poor canopy. I hope you manage to fix this okay.

Edited by PlaStix
Link to comment
Share on other sites

Well done! That must have been some job! I found it difficult doing much of anything in 1/144 let alone correcting a fault as bad as that was when you started. Neat job.

Link to comment
Share on other sites

i m calling GB policy for this one - the filler takes for sure more than 20% of the build! ;) Nono, seriously, thats a LOT of filling, but you did great job on that one :) i dont know what could stop you by now.. :)

  • Like 1
Link to comment
Share on other sites

  • 2 weeks later...

Do you reckon it'll be more filler? ;)

That was plan "B" :P Seriously, if my moulding attempts failed I was going to make one out of Milliput!

How are you going to make a replacement?? :hmmm:

I plunge moulded it. I used some scrap basla, 9 thou clear sheet, a couple of bulldog clips, the original canopy (which is slightly undersized, so ideal for moulding off), a toaster and a bit of scrap sprue as a handle for the canopy.

The smaller hole is for the Spit, the larger is for my Tempest. While I had everything set up, I thought it would be rude not to do both. :)

2014-05-0808582501_zpsb2b6798b.jpg

It worked well, you can even make out the canopy frame in the shadow.

2014-05-0808571501_zps26ccfa44.jpg

And this is why I had to make a new one. Really Minicraft!!?? Really!??!! THAT'S the best you can do!??!? :o Shame on you. :nono:

2014-05-0809031401_zpsa70b88cc.jpg

  • Like 2
Link to comment
Share on other sites

That looks pretty smart Speedman! I must learn how to plunge mould too, would be handy for all those Dragon F-18E's that I wanna make as F-18F's.

Still gotta be honest, I'm kinda disappointed you did not use filler for the canopy!! ;)

Kind Regards

Dazz

Link to comment
Share on other sites

I've neatened up the canopy frames and applied the awful decals. I've never had so many problems with a decal set as I've had with these. Not only are they grossly oversized, they also would not stay down. Even with Micro Set and numerous applications of Micro Sol the fuselage decals would not stay down at the top and bottom edges. In the end I used a tiny drop of CA and glued them!

Honestly, this kit has been an absolute nightmare from the start! It's disgusting how Minicraft can give these kits a RRP of £7 when you can buy the fantastic Eduard twin packs for £11! Even the £3 Zvezda snap kits are ten times better than Minicraft's offering.

2014-05-1522005601_zpseb96d63a.jpg

Link to comment
Share on other sites

 Share

×
×
  • Create New...