james007 Posted August 21, 2013 Share Posted August 21, 2013 Hello every one, I have white metal action figure & I would like to know what is the best way to fill gaps ? is it possible to use Tamiya putty basic ? I am looking for more than one way to do the job. Thanks Link to comment Share on other sites More sharing options...
Riggers Posted August 21, 2013 Share Posted August 21, 2013 Milliput I use. Goes rock hard & ready for sanding within a couple of hours. ATB Link to comment Share on other sites More sharing options...
Test Graham Posted August 21, 2013 Share Posted August 21, 2013 Low-melt solder? Link to comment Share on other sites More sharing options...
JonP Posted August 21, 2013 Share Posted August 21, 2013 Milliput or the more expensive Games Workshop two part Green Stuff should do the job; Link to comment Share on other sites More sharing options...
Mal Posted August 21, 2013 Share Posted August 21, 2013 If your confident and know how,use low melt solder,I've joined and filled many a boiler this way.if not use milliput. Malcolm Link to comment Share on other sites More sharing options...
james007 Posted August 21, 2013 Author Share Posted August 21, 2013 Thanks for the replies , is the Milliput an epoxy putty, since i have tamiya epoxy putty & it's two parts putty , are they the same ? Link to comment Share on other sites More sharing options...
pte1643 Posted August 21, 2013 Share Posted August 21, 2013 is the Milliput an epoxy putty, since i have tamiya epoxy putty & it's two parts putty , are they the same ? I've never actually used the Tamiya putty, but I'd suspect they are similar, if not the same. I would say that Milliput is cheaper and easier to get hold of though. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now