Search the Community
Showing results for tags 'romulan'.
Found 2 results
This is a very small (Federationmodels.com website says 1:3500 but I think it's 1:1000) Romulan scout ship from the TNG episode "The Defector" P1010307 by stephen.north66, on Flickr P1010308 by stephen.north66, on Flickr P1010301 by stephen.north66, on Flickr P1010302 by stephen.north66, on Flickr P1010303 by stephen.north66, on Flickr
amt 763 star trek cadet the original series 3 ships scale 1:2500 The 3 ships comprise: USS Enterprise, Romulan bird of prey, Klingon D7 battle cruiser Scale The photos include that unit of measurement of miniatures: a one pound coin. Is there a "bottom" in space? anyway here is the underside view: Comments on the Kit: Cute little models. Comprehensive decals are included. Display stand(s) are NOT included. Problems Poor fit: the tightness of the "snap-fit" parts is very variable. The Enterprise pods were sloppy and very difficult to align, the "V" shaped support was a very poor fit and needed lots of filler. The Klingon upper wing surface needed so much force to "snap" it into position that I popped the seams on the "neck" of the ship. The decals "grabbed" and needed lots of micro-set to allow them to be manouvred into position. Some of them were slightly too large for the surfaces and needed to be trimmed to fit. My Build notes This is my first sci-fi kit and I (foolishly) rushed into the build. With the benefit of hindsight I should have test fit and measured everything and carefully worked out how to locate the parts and how to align them. In most cases I think it would be best to drill out the locating holes and glue the parts rather than "snap-fitting". The Enterprise pods are not properly aligned, do do so would have required me to trim the mating surfaces of the left pod and the "V" strut more than I did. I didn't follow the painting instructions exactly, in the case of the Klingon ship I used part join lines as my painting demarcation lines, rather than masking off as directed (so sue me!). Stands I bought a set of clear Airfix stands and bodged up little "Y" shaped holders on top to support the craft. Conclusion With care this can build to a nice model. If I could figure out how to do it a "tree" stand supporting all three models in formation would be nice. (However I seem to be in a junior league compared to most of the posts on this site, some sort of levitation device would be better?)