Search the Community
Showing results for tags 'TAKOM 1/35'.
Found 4 results
-
copia.jpg.0a64908f8f42d2b91dcd4a4b80e30536.thumb.jpg.fa523834e2c51d793e1d3b558e6bb1dd.jpg)
Hi Pals, A small diorama with my last tank, a Takom Chieftain MK2, inspired by the kit's boxart and some photo of the real model. I add a link to the RTI, and another to the WIP, in case there is anyone interested in seeing more photos, with the model alone. Thanks for watch and comments. Cheers mates.- 18 replies
-
- 41
-
-
-
- COLD WAR
- TAKOM 1/35
- (and 1 more)
-
Hallo again Well, this is my second interior kit. My lessons learned from my Bergepanther G is the following: Do not get lost in detail in your first session. Check out all parts, which make up the main body. Check the rear wall with sidewalls in the engine compartment. Here is one of the lousiest flaws! If the sidewalls do not properly fit with the rear bearing for the tension axle, the game is a horror. Check out, that the gluing surface really fits at the bottom of the sidewall. The intersection with the rear bulkhead is also a point of major conflict. So I tested all this with the upp
-
Hi Pals, I have finished the model, along with its base. A well detailed OOB kit and easy to assemble, with the exception of the tracks, which are very laborious, although not particularly difficult. I added some small extra bit, such as the headlight wires, and the rearview mirror rods, and the strips of the barrel's thermal sleeve straps, as well as a pair of antennas. The only thing that could have focused better, is the behavior of the bogies of the undercarriage, when climbing the vehicle on the slope, although it is not too steep, and the so
- 40 replies
-
- 44
-
-
-
- COLD WAR
- CHIEFTAIN MK2
- (and 1 more)
-
Here is a big AA gun or at least one of the pair on the same mounting. This kit is a little more involved as there's lots of dry fitting, filling and sanding and the instructions leave one guessing lots of times. A different subject but one of these kits is more than enough.
