Search the Community
Showing results for tags 'T17'.
-
I've just acquired two Alley Cat resin conversions for the Airfix 1/48th Canberra; a T17 and TT18. Has anyone else built a Canberra using these? How do they fit, etc, anything to watch out for? I got them for about £20 each, hoping they're worth it! The decals included look good.
-
Evening all. I'm going to try again at a work in progress. I started one recently on my 1/48 B1 Lancer but since then a box containing all the landing gear etc.. has vanished so thats on hold. Its another Canberra for me, this time its a T17 which I am going to do WD955 in hemp. Thanks to Jinxman for selling me his Alley Cat conversion as I couldn't find one anywhere for sale. I started this kit about a week ago and have been doing major surgery on the fuselage section to allow the new canopy and nose to fit. With the Airfix Canberra I've found that the pilot sits far too low and too far back so I've put in a AIRES ejection seat. I know its not the proper one for the Canberra but its a MB Mk.4 which is as close as I could get. The Airfix supplied crew are far too small (hobbit size) so I also aquired a PJ productions RAF pilot. His size seems far more in proprtion. As I've raised the seat and brought it forward and also due to the resin nose section I have had to make some compromises with the instrument display, it is now attached to the underside of the canopy section and has been made substantially smaller to allow a good fit. I've used the Airfix crew and seats in the rear as they will probably not be seen. Another gripe I have with the Airfix kit is the trench like panel lines which bear little or no resemblance to any Canberra so I have filled all the panel lines. So far everything is fitting reasonably well. Here are some pics so far.... That last photo looks really rough.... It honestly looks better in the flesh, I have also to add some PE to the pilot seat to finish it. All comments and advice welcome.. Mark.
-
Morning all. Just finished this one, its the 1/48 Airfix B2 with the Alley Cat T17 conversion. Everything fitted really well except for the pilot and seat which needed some shoogling about to fit properly. It has the PJ productions modern RAF pilot,an Airies ejector seat, and resin wheelbays. Its painted with Halfords car spraypaint (Rover champagne biege upper and racking grey undersides) and finished with a spray of halfords matt lacquer, Ive also filled all the panel lines.. I've given it very light weathering, photos I have seen of the real aircraft either show it very clean or very dirty. The only issue I'm having is condensation inside the canopy. I gave it a good wash down before painting and I thought it was thoroughly dry but some moisture has obviously got inside and doesn't now want to leave. Also, I need a good idea of what to use as aerial wire, I resorted to using fine jewelery wire but its not tight enough and looks a bit wrong.. Heres some photos (photography is not my strong point and are done on a camera phone). Some outdoor shots... And here she is with my growing fleet of Canberras (a PR7 and PR9) All comments welcome..
- 16 replies
-
- 15