Search the Community
Showing results for tags 'ScudB'.
Found 1 result
So, I have started this mammoth build... this kit appears to be fully detailed with every part of the original vehicle reproduced. I started an update build on the dragon kit a couple of years ago, and from memory, this kit seems pretty accurate.. like I said.. from memory. The Frame rails simply clip together, and stay together the fit is that good!! Here they are, top and bottom.. look at all that lovely detail!! Step One of the instructions has you build up one side of the frame, as does step 2 and 3 before adding the left rail. I have clipped the frame together as shown above and glued the relevant parts as required in step one to the right rail. The whole thing was then weighted down on a flat surface to ensure the frame comes out square and flat. Here we can see the right rail with step one's parts fitted and the diffs in the foreground. I remade the drive shafts from 2mm rod as the trumpeter shafts were very oval after the seam clean up.. probably my fault?? The Diffs close up, note even the lifting eye is included in the kit. Here's step one of the instructions. Anyway, here's stage two of the build.. very nice detail and good accuracy.. Close up, note the little lifting eyes supplied on the transfer box.. and the moulded on weld seams on the air tanks. Very nice!! And finally, stage 2 instruction manual..