Search the Community

Evening All, The second subject for the Gordon Bennett racers of 1911 is the Bleriot XXIII. This is causing me a few problems because only two of the type were constructed, (they were built as racing aeroplanes), and apart from a handful of photographs, I have little information about them. There are no drawings that I am aware of. I have a dimension for the wingspan, (17 feet), which is incredibly narrow, and a wing area, so I think that I can calculate the chord. Sources state that the wings of the original design were longer but were reduced by approximately 1 metre before the Eastchurch race. I also know the length of the aircraft and that they were powered by 100 hp Gnome Double Omega engines. Photographs show that the original wingtips were rounded, but for the race they were square. The fuselage seems to have been developed from the earlier two seat XXI, although the latter had a much shallower fuselage, especially at the rear. Both types had a large horizontal tail surface and a rudder but no fin, although the shape of the rudders was different. I am therefore making my own drawings and writing the assembly instructions at the same time.... I make no claims to accuracy of these models - they will be the best that I can do given the source material available. However I am pretty certain that there is nobody who can challenge the overall shape even if some details are not 100% accurate. I am making two models to represent the two aircraft but as with the Nieuport IV I am only illustrating the build of one model: I will show photographs of both when they are complete. I have started as usual by cutting the wing blanks from 30 thou card bent in hot water in a pipe with 10 x 20 thou Evergreen strip for ribs. The strip was sanded almost flat and the Mr Surfacer added to smooth the edges. I have made the rudders in the same way from flat card. The fuselage sides, top and bottom were cut from 30 thou card and pieces of scrap plastic added to keep the joints square. I added some 10 x 20 thou strip to represent the frame in the cockpit area, I have cut a floor and painted it wood, and made a control yoke from 20 thou and 80 thou rod. The engines were made from thick sprue for the crankcase with 30 thou rod for the cylinders. I have painted this assembly but not added the push rods yet: The seats were made from scrap card for the base and 10 thou card with holes drilled for the back. I am carving the propellors from hardwood using plans from the DataFile no 108 of the Bleriot XI at War. I cut the wood into strips of suitable length, marked on the shape of the propellor and filed the shape that I wanted. I will add bosses later from thin card: I shall use the DataFile plans to make the undercarriage and to help with the shape of the fuselage as the XXIII was clearly derived from this earlier design. Thanks for looking: more to follow when I have made more progress. P

In May 1940 the BEF found itself with its back to the wall and the call went out for the ships to rescue them. Various Naval vessels and over 600 'Little Ships' set out to rescue them from the harbour and beaches, This is my tribute to those men and boats that didn't come back WIP https://www.britmodeller.com/forums/index.php?/topic/235064445-dunkirk-tribute-completed/ Thanks to everyone who has supported and encouraged me along the way Stay safe Kev Ps BBC 2 tonight 7pm little ships