This site uses cookies! Learn More
Search the Community
Showing results for tags 'Scout'.
Found 8 results
-
Scout & Wasp out next year late...... both in 1/72 Wasp also in 1/48 Scout also in 1/35 !
- 51 replies
-
- 16
-
-
-
AMP is to release a 1/48th Boeing YL-15 Scout kit - ref. Source: https://www.facebook.com/story.php?story_fbid=2444412328969822&id=1416295571781508 V.P.
-
Two Scouts completed for Eleventh Hour GB, a Libra vac and Mac kits. Couldn't help doing a group shot with a Pegasus Bristol M1C
-
Hello All, A bit late to the party but here is my project, two Bristol Scouts, one injection moulded by MAC and a vacform by Libra. Some spare parts from the MAC one including decals will be used in the vac build. Not decided schemes yet but the Libra will be a 'D' and the MAC a 'C' Just noticed the Libra kit is issue 001, would have been a collectors item if I hadn't already started chopping it up! -
With the Lincoln done, it's time to make a serious start on the Scout. I've started with the old Fujimi 1/50 Westland Wasp kit, which isn't too bad in outline but is low on detail. As many here will know, the Wasp differs from the Scout primarily in the undercarriage and rear tail areas. I've removed the offending undercarriage support areas and antenna lump from the lower fuselage and cut the rear part of the fin away (saw disc on the Dremel works wonders!). Unfortunately, it's left a rather ragged hole which I'm going to have to fill after joining the halves permanently. There are a lot of rivets on this kit and, in this case, I need to retain them as much as possible as they are quite prominent on the real aircraft being domed rivets, rather than flush (pretty much the standard for helicopters due to their low speed). I reckon some of the bits I cut off the Lancaster for the Lincoln conversion will fit the bill nicely, as they already have rivet detail on the plastic but if not, I've bought some stick-on rivets to add later. I'll use the same for the fin and (possibly) the horizontal stab, both of which will need to be made from scratch. The instrument panel is extremely basic and incorrect, so I'll build a new one from plasticard using my new punch set from MicroMark and the excellent Airscale decals. Scratchbuilt instrument panel is in progress, as are the internal mods needed. I'll be tinting the upper canopy windows with Future and blue food colour, too.
- 70 replies
-
- 11
-
-
Special Hobby is to release a 1/32nd Bristol M1C Monoplane Scout kit - ref. SH32057 Source: http://www.modelforum.cz/viewtopic.php?f=97&p=1580692#p1580692 V.P. -
Westland Scout AH.1 XT617, pics mine taken at Wattisham Station Heritage Museum.
-
Bristol M.1C Monoplane Scout. Pics thanks to Mark Mills. This aircraft is replica built for the Shuttleworth Collection but it uses an original 110hp Le Rhone engine.
