Search the Community
Showing results for tags 'Scalewarships.com'.
-
HMS Hood Replacement Funnel Scalewarships.com 1:200 Whilst Trumpeter got the funnels correct in their 1:350 and 1:700 releases, for some strange reason they got the aft funnel on their 1:200 release very wrong. The kits aft funnel is smaller than the foreward one, whereas they should be the same. Now, Pontos Models have released a huge update set that actually includes a replacement funnel and its accessories, but the price may put some modellers off. This is where Scalewarships.com come in with their release of a set that only includes the funnel, thus keeping costs down. The set includes a beautifully cast resin funnel, two funnel bases, one with a clipped end, and an alternative one with angular sides. There is also a new funnel cap to finish off the ensemble. The single large sheet of relief etched brass includes the funnel cap, upper and lower hand and foot rails, walkway, alternative walkway, and their respective walkways, along with walkway supports and capping pieces for the funnel cap cage. The instructions are nice a clearly written out, although with only one picture as a guide. The resin parts will need some cleaning up and finishing off, not to mention cleaning with warm soapy water. Conclusion This is another great little addition to the modellers arsenal and allowing the modeller the choice of buying the super expensive Pontos or Mk1 Designs sets, when you ‘d only need to buy this set to make the kit that much more accurate, and the modeller these days always needs options.
-
HMS Hood Splinter Shields Scalewarships.com 1:200 The set also includes the raised shields either side of the main turret mounting, bridge shields, bridge windows, and also replacement bridge overhangs, should you damage them whilst fitting the bridge shields. As with the degaussing cable set reviewed HERE, this set also goes to replace the incorrect parts of the ship that are most noticeable. In this case it’s some of the splinter shields. Namely the ends of the mid shelter deck 4” gun turret shield, the aft quarter shields, and three areas of the aftermost shield, also on the shelter deck. The offending kit mouldings will need to be carefully shaved off and replaced with the PE parts, which also include the inner face supports. Conclusion This is another very useful and cheap way to improve on this epic kit, along with the degaussing cable and the new funnel set, due in time for Telford, this is great way for the budget conscious modeller to improve their model.