Last Christmas I received both the X-Wing and the First Order Tie Fighter kits. I'm kind of on a Star Wars building kick at the moment and decided to pull this one out of the stash and get started on it. It is Interesting to note that while this kit can be displayed in flight, there is no pilot figure. With this said, I went to the spares box and found a helicopter pilot that would fit the bill nicely for a Resistance Pilot.
These kits are prepainted, albeit not very well. I decided to leave the cockpit as-is and do a little dry brushing to enhance some details. I glued the pilot in the cockpit and pressed the cockpit into place.
I began work on the S-Foils and the fit on the some of the parts were less than stellar. I know it's a snap tite kit, but I guess I set my expectations too high for a model kit tooled in the 21st century. There were some pretty big gaps to fill in the panels.
Once the filling and sanded were done and the factory paint job left a lot to be desired, I stripped the paint and primed the entire kit with Tamiya Gray Surfacing Primer.