Search the Community

A Tamiya classic, I've built this before straight from the box and it goes together fine, the original looks like this; Flakpanzer Gepard 2 by phil da greek, on Flickr I was reading an article on Wikipedia last summer about Canadian forces in Germany towards the end of the Cold War and what assests they had & this led me on to the development of the ADATS system and being a little bit bored i found that 4 (Air Defence) Regiment were responsible for defending the main Canadian base at Baden Soellingen and used the towed 35mm canon that the Gepard used. So what if the Cold War hadn't ended? If ADATS had been developed would it have needed a mobile gun system to support it? Sure, why not? So here it is, the Gepard (enhanced). The new system uses the same basic vehicle but has an improved search radar on a raisable mast, a FLIR turret which is again on a mast with improved electronics and an increased fuel capacity to support longer running times for the vehicles electrical system. Isn't imagination great? I lost interest with this a little bit towards the end but i think it turned out okay at the end and if nothing else it was fun and kept me ticking over during the winter. Brush painted in Humbrol 30 which is the suggestion i have found for the Canadian green and finished with Winsor & Newton Galleria varnishes. I did have some Canadian decals but i decided to use the box German decals keeping the Canadian ones for an up and coming project. The Tamiya boxing and the donor kit from the stash which has sat there for years and gave up it's turret and a couple of other bits. Gepard 2 by phil da greek, on Flickr Gerard 1 by phil da greek, on Flickr Onto the final model, all the photos were taken on a Canon Sure Shot 720 set to auto, taken in the conservatory without direct light, the white background is awful but the black background is much better. Gepard 15 by phil da greek, on Flickr Gepard 19 by phil da greek, on Flickr Gepard 17 by phil da greek, on Flickr Gepard 20 by phil da greek, on Flickr Gepard 18 by phil da greek, on Flickr Gepard 16 by phil da greek, on Flickr Gepard 21 by phil da greek, on Flickr As always, thanks for looking.

Gepard SPAAG A1/A2 Bundeswehr Flakpanzer Takom 1:35 The German Army had fielded many different Flakpanzers through WWII, and it was no surprise that they would continue this into the cold war. The Gepard or Cheetah was developed to fill this role in the 1960's with deployment beginning in the early 1970's. The system used the proven chassis of the Leopard 1 tank carrying a large turret carrying the two 35mm auto cannons and radar dishes. The anti-aircraft system combines two radar dishes; a general search radar, and a tracking radar/ There is also a Laser rangefinder. The German systems featured an S band radar for search, and a Ku Band radar for tracking, where as the Dutch systems featured an X and Xu bad radars. The German system having a search & track range of 15kms, the Dutch having a search of 15kms, but track of only 13kms. The gun system fitted is a twin 35mm Oerlikon KDA system. Each gun can fire 550 rounds per minute. They fire a Frangible Armour Piercing Discarding Sabot and Armour piercing ammunition with a range of 5.5kms. The usual load is 320 frangible and 20 AP rounds per gun. The German Army would order 377 units, the Dutch 95 and the Belgians 55 which were identical to the German ones. The Germans retired the units in 2010 but they are in storage. The Dutch and Belgian units have now been withdrawn form service. The system is still used in other countries though. Brazil has 36, and Roumania 43 from Germany. Jordan purchased 60 from the Dutch. The Kit Like many kits this was earlier kitted by Tamyia, and now the Takom version will battle it out with a Meng kit and a Hobby Boss one. A fairly packed box arrives from Takom here. Along with the main upper & lower hull plus the Turret there are four main sprues of parts, two sprues of suspension/wheel components; and three spures of track components (plus a bag of flexible parts). In addition there is a clear sprue, a sheet of photo etch, two metal tow cable, and a small sheet of decals. Construction starts with the lower hull, various suspension components are added and the wheels are built up. There are two drive sprockets, two idler wheels and 7 pairs of road wheels (on each side). Holes need to be drilled in the lower hull where indicated for attaching parts later on. Normally the next stage is to put the tracks on. Takom have failed to include great instructions for this. The tracks supplied are on 3 sprues of injected plastic with 6 runs of soft vinyl end covers. After some research on the net it seems these are made by a company called Orochi. The individual track links are moulded as one part with the track on one side, and the pads on the other. They clip together with the guide horns. The vinyl end caps are then slid onto pins on the end of the links. The end connectors can be slid on while they are still on their sprues according to what I have read. I could find no information about how many are needed for each side. Following construction of the lower hull, the modeller then moves to the upper hull. The hatches and lights are added along with other parts for the upper hull. These include the engine exhaust grilles, stowage boxes and a large insert which will take the Gepard turret as opposed to the normal tank one. The lower and uppers hulls can then be joined and the rear part of the hull added. Now its onto the main event for the Gepard the turret and guns. The main turret is moulded as one part. The first item to be added is the large main hatch. After this it is the main radar system at the front. Following this the guns are made up. The barrels are two part with different muzzle ends depending on the version being modelled (though not much information on the instruction sheet for this). The main housings either side are built up first and the guns added. Once the housings are added to the hull they join in the middle of the turret to ensure the move as a pair. Once the guns are on the turret the turret floor can be added. The rear radar unit which forms the back of the turret is now constructed and added to the turret. The radar can be in the raised or travel position. Various turret fittings are added and then the complete turret can be fitted to the main hull. Lastly stowage is added to the hull and turret. Decals A small decal sheet is provided as these carries few markings in service. Eight markings options are offered in the kit. German Army - All over green German Army 3 colour camo German Army 3 colour camo - KFOR operations Romanian Army - German 3 colour camo German Army - 3 colour desert camo German Army - Cheetah spot scheme Belgian Army - Overall green Brazilian Army - German 3 colour camo Conclusion This is a really nice kit. Very highly recommended despite the less than great instructions. Review sample courtesy of UK Distributors for