Search the Community
Showing results for tags 'Corrected parts'.
Found 1 result
-
This is my build of mengs me 410 b2/u2/r2. In the markings of 3U+CK of 2./zg 26. While based at Konigsberg-Neumark in the summer of 1944 The following aftermarket items were used Aires. - resin cockpit. Vector. - corrected oilcoolers. The following Quickboost. - ju 88 c/g 151 20mm gun barrels (under fuselarge gun pack). Ju 88 mg 151 20 mm gunbarrels (internal gun pack). Me 410 spinners & propellers. The following lead wire. 2mm,. 4mm,. 6mm. (engine & cockpit details & brake lines). Streached sprue was used for the radio aireal Extracolor enamels were used for the following rlm colours. - 02, 66, 74, 75, 76, Humbrol were used for the rest. A Badger 200 g was used with a fine tip. For the weathering the following was used. - Mrp. - exhaust soot Pastels Ak. - aircraft engine effects I enjoyed this build but! (I did a wip of this build) and would build another I had a couple of issues 1.the lower port wing joint needed filled with a plastic shim 2. The biggest issues were with the canopie. If you fit the nose glazing to the fuselarge the main canopie is too wide for the fuselarge. So I fitted the main conopie to the fuselarge so it fitted. Then used plastic card to pack out the nose glazing to fit the wider fuselarge. Also the conopie is on the thick side so I also had an issue fitting it round the rear aiming controls This is the detail I added to the gun/bomb bay(which is mostly hidden by the gun pack) Thank you for looking, comments and feed back is welcomed. Nick
- 20 replies
-
- 42
-
-
- 1/48
- Corrected parts
- (and 1 more)
