Search the Community
Showing results for tags 'Boba Fett'.
Found 2 results
Boba Fett's Slave 1 Finemolds 1/72 Hi everyone This is Finemolds 1/72 Slave 1, Boba Fett's customised Firespray patrol ship, built August-September 2014. I added some fibre optics to the cockpit instrument panel and backwall along with LED accent lighting and hull lights. The paint chipping was done with masking fluid applied with a sponge. Paints are a combination of Vallejo, Tamiya and Gunze. The long term plan for this is to construct a maintenance bay dio for it to sit in, hence the removed hull panels and port blaster. Hopefully, I'll get a chance to do that this year, time permitting. Hope you enjoy the shots *2019 Update* I was looking over the original shots I took of Slave 1 recently and, to be honest, they were embarrassingly shoddy. On top of that, I've also added a little extra weathering since the build was finished, so overall it seemed like a new set of photos would be a good idea. The extra weathering mainly consisted of some additional brush painted chipping to enhance the existing masking fluid chips and a bit of post shading with some heavily thinned Tamiya dark brown, particularly over and around the glazing which had looked a little too clean and shiny before. I didn't have a battery to hand when taking these shots, so the lighting isn't on. I'll leave one of the original shots at the end so you can still see it lit up Hope you enjoy the new shots Thanks for looking Andy
Slave 1 Main Nozzles (01115-1/144) 1:144 GreenStrawberry Boba Fett's ship the Slave 1 is one of the memorable designs from the Original trilogy of Star Wars films, and even put in an appearance in the Prequels in a slightly better state of repair under the helm of Boba's dad Jango. The Bandai kit is an excellent rendition of this craft, and if you have both the Boba Fett and Jango Fett boxings, you're going to need two of these. The set arrives in a small cardboard box, with the three resin parts safely inside a small ziplok bag, surrounded by the short and mostly pictorial instruction sheet. The underside of Slave 1 becomes the rear when in flight, and shows three exhausts, one of which is elongated, the others round. The kit parts are probably adequate for a lot of folks, but for the detail hungry, these replacements will be just the job. Each one is covered in detail, especially within the round exhausts, which have exquisite interior ribbing that would be impossible for your average modeller to carry off. The modeller will have to ensure that any raised detail under the exhausts is removed from the base, and once the parts are cut from their bases, which is clear from the instructions, they can be glued in using Super Glue (CA), most likely after painting. If you want to see one solitary photo that will convince you, here it is – lifted from their site: Extremely highly recommended. Review sample courtesy of