Search the Community
Showing results for tags 'An-12BK-PPS'.
-
Hi everyone This is my 1/72 AN-12BK-PPs by Roden. This is one of the most challenging kits I have made, due to the bad fit and quality of parts. The inside was well detailed but is difficult to see through the small windows. I had to fit in about a hundred grams of weight to stop it tail sitting. The panel lines were either deep or so shallow you could barley see them. I had to do a lot of sanding and filling between were the fuselage parts and the tail where attached. I painted it in Mig-0208 Dark compass ghost grey. The decals did not conform well even after having micro sol applied many times and a few of them tore when being positioned. In the end I had to pull a cocktail stick along the decals to make them conformed. Thanks for looking
- 18 replies
-
- 48
-
- Russain
- An-12BK-PPS
-
(and 1 more)
Tagged with:
-
I start Antonov 12 BK (Cub) Soviet Union main transport on Cold War. Dimensions are as much a C-130 at 1/72, 46 cm long (fuselage). I wanted to turn it into SAANXI with a Venezuelan camouflage, which is also impressive, but the protrusion of the front fuselage has been a reflection of the diminution of the windows. I will turn it into PPS electronic warfare. The Roden kit is available for PPS. There are three types of PPs. One with a new tail without guns. second with a cabin but without guns and a third with a cabin and guns. I will make the third type as in the design. For this reason I built the pods with balsa. There should also be a dozen air intakes on fuselage and spindle antennas (circular). Because I want to get away from the simple look of the simple transport aircraft. I 'll try put lights. motors and open-close the rear door. That's what I'm saying ..