I'm currently building the Yak-28 Firebar from Bobcat models. My one criticism so far would be the slightly vague instructions which do need to be followed closely as this kit is not of usual parts breakdown r build sequence. I'm really not able to fathom where parts E14 & E15 go. They look to represent some sort of cockpit wiring in the front cockpit but the instructions just show them "arrowed" to fit either side of the tub. Test fitting does not seem to offer any room for them to fit where suggested and a small inset shows just a hint of the rear of the part looking to overlap the top edge of the tub, just above part B32 which I think represents an IP lamp I've had a look at the online builds here on Britmodeller but a) a lot of pictures have died with Photobuckets rule change and b, those that remain don't show the area in question. Any builders able to help me out?
The tub itself is also a bit of a vague dry fit but adding the front wheel well when I actually apply glue might help that. Not looking forward to avoiding snapping off the complex front U/C though. Did anyone manage to work out a way to install after main construction? I don't want to chop off the ends of the locating pegs and then find they are too short to properly locate!