Search the Community
Showing results for tags 'model.'.
-
Good morning, I just thought I might ask the advice and opinions of members of the forum in regards to a project i'm starting. I was thinking of doing a 1:72 Airfix Vulcan "properly"; with aftermarket engines, intakes (possibly, you'll see later) and the white ensign model (WEM) stuff. I've also thought it might be an appropriate model to do some rescribing for the first time, along with flory washes, photo etch and resin- I had to choose this model So the few questions I would like to ask are as follows: 1. Can you use a steel ruler and is it adviseable for linear panel lines as a guide- rather than masking tape? 2. (Perhaps the most important decision) Which Vulcan to do?! I've got a choice between XH558 and XL360- having been in XL360 and purely because I quite like the 617 tail marking (I might be turning into an "anorak" ) I feel a greater sense of attachment to her, although I have seen XH558 display at Throckmorton last year and so I am quite keen on her too! 3. Should I have "everything" open (gear down, airbrakes down, bomb bay doors open, crew hatch open)? Or should I save some money and (if I should choose XL360) build the Coventry Vulcan as it currently is (and save additional money with FOD covers for the ghastly kit intakes)? Note: I would have built the Cosford Vulcan but I'm not keen on the highly glossed finish of XM598 4. Any other advice for building the Airfix kit? Joins to watch out for, etc. I know that 2 and 3 are very subjective points but I would greatly value your opinions. Many thanks, Sam Edit: the 617 tail marking on XL360 Edit 2: -Are there any definitive colour matches out there for either 558 or 360?