Thank you all so very much.
Thorfinn,
I made the AN/ALQ-144 "Disco Ball" by sanding the PE piece from the Eduards (set # 73-274) until all of the silver coating was removed and the brass was revealed completely. Next I polished the brass with a piece of fine sandpaper to give it a high shine look, and sprayed a coat of Model Master Acrylic Clear Red over it. I Let this dry for a day or so. I then cut a piece of clear Mylar film, which was purchased at Hobby Lobby, to fit over the PE piece. Making sure it was a little bigger than the piece to be covered, this allowed me to handle it better. I brushed a coat of Future/Klear over the PE piece and lay the Mylar over it while it is still wet. I gently press this down and let it set for a while.
After this was dry I used a new #11 blade and scored the recesses between each of the lenses on the disco ball. After this was done I brushed another coat of Future/Klear over it,and let this dry. Finally I trimmed all excess Mylar, folded the piece to shape, and covered it one more time with Future/Klear. You may have a lense pop off here or there, if this happens just cut a piece of Mylar to the correct size and reattach it with Future/Klear. This also works on kit supplied units, just make sure you have lay down a good metallic paint for the clear red to go over.
Thanks again everyone,
Dave Fassett