Hi all,
Years ago I got this kit simply to nick and paint some ASRAAMS for a diecast Typhoon. Since then there's been a better release. I had a few kits for spare parts like that. In the end though, I figured this is as good a kit as any to learn the trade and it wouldn't be heart-wrenching if it were to go horribly wrong. (or so I thought)
The last kit I ever built was this Hasegawa 1/48 Phantom 25 years ago. Back then I used enamels without any primer, thinner, painted everything by hand and had only just figured out how to use masking tape properly. After applying decals I didn't realize the need to varnish. It strangely actually turned out somewhat ok, but suffice it to say, nothing from back in the day really survived.
So now I figured I would invest in the right tools to do things properly. I started this up 2 years ago, while I was living in China, where Tamiya and mr. Hobby stuff was much more available than anything else, so I mostly ended up using a mix of Gunze and Tamiya enamels for hand painting.
Bought a compressor and Tamiya airbrush (liked the interchangeable cup) and had at it. The nozzle is 3mm, which I thought might be a good compromise for small and larger areas.
Started off by priming everything with a 50/50 mix of mr. Surfacer 1200 and Gunze leveling thinner while it was still on the sprues. In hindsight, I would have been better off assembling everything first and maybe spraying a slightly thicker primer on the seam lines. The tamiya putty was a bit nasty, I much preferred the water soluble vallejo stuff. It filled all the nooks and crannies fine, but it still meant a lot of sanding to improve the fit. I ended up hand painting some mr. Surfacer 500 on some seams and then sanding them down, but the result was not great as I ended up with it a bit too thick in places and sanding away some detail too.
Cockpit turned out ok. Tried mr. Mark setter and Mark softer for the first time too. I didn't realize just quite how floppy it would make the decals. It looks great when it conforms to the surface, but I had a hell of a time moving it into place properly. Suffice it to say, I had to learn to apply it after it was in the right place and even then only very gently.
Then hand painted the pilot with Tamiya enamels based on reference pics. Only the helmet is Gunze 306.
I then tried to varnish it with a matt mr. hobby Topcoat, which resulted in some pretty bad grey streaks. I thought initially it may be a reaction to the enamel paints, but it was all over the cockpit too. I still can't quite explain it, it may just have been sitting too long. I repainted some of it and just installed the cockpit as is.
Next I did the canopy interior. I wanted to see if it could be done, but making a mask for both interior and exterior took forever. Next time, I just buy some masks and only spray the outside in layers.
After that, started the main assembly. The exhausts were all done in Gunze burnt iron, while I tried to pre-shade the main body with Gunze flat black.