Hi All,
I have an H&S Evolution Silverline 2 in 1. My problem is that it regularly stops spraying after a few seconds when using the 0.2 needle and doing fine work. If I release the trigger and try again it will work, but then peter out again. I open up the paint volume control and it will work but then I suddenly get a flood of paint. So I can't seem to get a happy medium consistantly.
The compressor is set to 15psi and I thin the paint 50/50 with MLT. I use Mr Hobby (paint & surfacer), Tamiya, Alcad etc. As an example, I was flat coating with GX113 50/50 yesterday and it did it again. On this occassion I did notice the needle was stuck in the nozzle and was not pulling back. But it still did it after adjustng the needle.
I am almost OCD about keeping it clean! It's not dry tip (I only get that with UMP primer). I have just replaced all the seals.
I don't push the needle hard into the body, but i am wondering if the nozzle is the cause. However, I have looked at it under magnification and it looks ok. Should I just bite the bullet and buy a new nozzle and needle?
Shine On,
Pink