Hi,
Just got back into the hobby and having a problem already.
I got some Vallejo surface primer and despite supposedly being able to use it straight from the bottle,it clogged my airbrush.
Did a little research and found this was quite common,so used a little thinners and all was good.
I am now onto my second model and today decided to prime it,so thinned the primer,put the cap on and started spraying.Within seconds my airbrush had clogged and the paint had changed consistency with lumps in it.Used the same thinners and ratio as last time so a bit confused here.
After a thorough clean,I decided to try thinning with a small amount of water,which worked,but the paint went on really watery and eventually clogged once again.
I`m now looking for a different primer,any recommendations? Also not happy with the finish I got as there are some runs,so whats the best way to remove it without damaging the plastic?
Thanks