-
Posts
1,262 -
Joined
-
Last visited
-
Days Won
2
Content Type
Events
Profiles
Forums
Media Demo
Everything posted by Sebastien
-
Thanks! S.
-
I've corrected the nacelle a bit, i just need to do the rear end. If you see any mistake, could you please point them? I'm not quite satisfied with the panel lines rearwards of the wheel well, I'm going to redo them. TIA, Sébastien
-
Well, it sure seems they were: Cheers, S.
-
Thank you so much! S.
-
I think I'm not that far away from the correct shape. Could I have your opinion? TIA, S.
-
I have started drawing the part, but I'll happily take whatever you can send my way. Thanks a lot! S.
-
That does help. Thank you very much! S.
-
Hi, I am designing engine nacelles for the 1/48 Sanger Shackletons. I think I have nailed the engine itself pretty good, as well as the outer engine nacelle and the inner nacelle for the taildraggers. The MR3 nacelle is rather different, and I have trouble figuring its shape. Could anyone near a real Shackleton MR3 take a picture of the inner nacelle from the front (ideally levell with the lower lip of the cowling)? Or could anyone near a Revell MR3 do the same thing with their model? Thanks, Sébastien
-
It wasn't a typo, I really meant Titan's C-17...
-
You'll be better off with the projected 1/48 Titan Models one, then...
-
Hi, I have 10 base layers and ten transition layers. S.
-
Hi, Thanks to all. I'll try reducing the support size, as well as the exposure time for the bottom layers. To be continued, S.
-
The final result of yesterday's print:
-
@PeteH1969 I rub the plate with IPA , and dry the plate before doing a new print. @Jo NZ, I changed the printer firmware before I changed the screen. Sébastien
-
Pete, The support base is peppered with 2 mm diametre holes. Sébastien
-
Thanks a lot! S.
-
Hi, I did it twice. I use Voxeldance Tango (I used it before my problems, and I have used files made with it to print the parts you see). S.
-
I have made a set of engines for Sanger Shackleton. I used to print 2 engines and the outer nacelles in one go. I've changed the LCD screen (it died on me unexpectedly) and the nFEP film. And I get that: Same resin, same heater setting, same parameters... What did I do wrong this time ? TIA, S.
-
You Philistine you. It will be a 1/48 Stranraer. And this is not a wish. It's a fact. S., still busy with that bloody Shackleton engine nacelle
-
1/48th Boeing B-52H Stratofortress (Sanger vacuform)
Sebastien replied to tomprobert's topic in Work in Progress - Aircraft
That's fabulous. Sébastien -
1:48 Fairchild Republic Thunderbolt II - Warthog by GWH
Sebastien replied to Greg B's topic in The Rumourmonger
An A-10A is supposed to be released after that one IIRC. S. -
I've decided to use the squishy thing between my ears for a change. I have baroque results when I print the nacelle without the gear doors. So I made a chamfer around the gear doors (to ease the separation between the doors and the nacelle) and combined them to the nacelle. This should work much better... S.
-
Hi, Thanks to both. There's no bulkhead. I've added support, it's in the printer right now. S.