Shar2 Posted September 26, 2017 Share Posted September 26, 2017 Corsair Cowl Set Brassin 1:32 Cowl Set (632105) It’s been quite a while since Eduard last released some resin for one of Tamiya’s 1:32 Chance Vought F4U Corsairs, certainly for the first one, the F4U-1. This they have done though with the release of this cowl set. As with the majority of Brassin sets, this one comes in a cardboard box inside of which is one bag of resin parts, and a small sheet of etched brass. These are all very well protected by blocks of foam. The large instruction sheet is very well laid out clear, and certainly a big improvement on the standard instruction sheets. The larger parts look pretty easy to remove and clean up as they are only attached to the moulding block on one edge. The contains five resin parts, the cowling nose section, two resin cowling side panels, and two styles of cowl flaps. When all the parts are assembled, including the fitting of four brass hinges on the side panels, Nothing of the beautiful kit engine will be seen, so, if you wish to show the engine off and use this set, you will need to carry out some surgery on both the resin and the brass and prop them open, or leave them off completely in a diorama. Conclusion The Tamiya F-4U Corsair is already an outstanding kit with very few problems or vices that haven’t already been fixed by other aftermarket companies. But this resin cowling is actually thinner than the kit items and actually better looking. They are very simple to use as all the flap actuators are moulded in place, so no fiddly etch brass to worry about. Review samples courtesy of 1 Link to comment Share on other sites More sharing options...
hacker Posted September 26, 2017 Share Posted September 26, 2017 wish there was a cowl fix for the Trumpeter U4B but alas not to be. Might get this one for a project l will be working one Hacker the thinker....yeah dangerous thing to do Link to comment Share on other sites More sharing options...
Shar2 Posted September 26, 2017 Author Share Posted September 26, 2017 I don't believe there was one. But you should be able to make this fit if it's the right mark. Link to comment Share on other sites More sharing options...
corsaircorp Posted September 27, 2017 Share Posted September 27, 2017 8 hours ago, hacker said: wish there was a cowl fix for the Trumpeter U4B but alas not to be. Might get this one for a project l will be working one Hacker the thinker....yeah dangerous thing to do Hello Hacker, I did it, must finish it But the belly is equally bad shaped ! This is 1/48 of course ! the 1/32 are the same insanity ! It's a matter of plasticard and putty aaaaand sanding ! Sincerely. Corsaircorp Link to comment Share on other sites More sharing options...
corsaircorp Posted September 27, 2017 Share Posted September 27, 2017 Here's the way to do, On the left is Hasegawa, trumpy on the middle and Academy is on the right. Sincerely. CC Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now