Jump to content

Spitfire Mk. IXc Detail Sets for Revell. 1:32 Brassin


Shar2

Recommended Posts

Supermarine Spitfire Mk. IXc Detail Sets

1:32 Eduard/Brassin

pack2.jpg

 

The Revell Mk.IXc Spitfire has been out a little while now, and, strangely, Eduard have been a little slow in getting stuff out for it, but they have finally caught up with a vengeance with a shed load of sets, both etched and resin to enhance and super detail what is already a nice kit. I will be dealing with the resin sets in this review and the etched in a later article.

 

632-106 – 4 Spoke Wheels. This simple direct replacement set, provides new tyres, inner hubs with brake detail and outer four spoke hubs, along with a new, single piece tailwheel. The tyre, which have no tread, but nice sidewall detail and wording, are, as with the outer hubs only tentatively attached to the moulding blocks, so require minimal cleanup before glue together, but the inner hubs are mounted to the moulding block on their rear face, so will need to be carefully removed and take a bit more cleaning up before gluing into position. The tailwheel is even simpler to use, just remove from moulding block and fit where the kit part would go, job done.

 

4spokewheels.jpg

 

bin.jpg

 

632-107 – 5 Spoke Wheels. This set consists of the same parts as set 632-106 above, with just the outer hubs being of the five spoke design.

 

5spokewheels.jpg

 

bin.jpg

 

632-108 – Fishtail Exhaust Stacks. This set contains two exhaust stacks that are drop in replacements for the kit parts. Nicely moulded, each stack has a more prominent opening, but I still feel they could have been a little deeper, but once painted they should look a lot better than the kit parts.

 

exhausts.jpg

 

bin.jpg

 

632-109 – Undercarriage Legs and Doors. This set contains a very nice pair of main undercarriage legs, in bronze, making them very strong, perfect for a kit that has been laden down with resin and etched brass. In addition there is a pair of main undercarriage doors in resin.  These are nice and thin with good rivet detail ont eh outer face and moulded brake pipe on the inner face. Some modellers may want to replace the pipe, but it does look ok to be left if you want.

 

mainlegs.jpg

 

bin.jpg

Conclusion

Eduard have released a nice selection of parts in these sets.  They are all well moulded and detailed, perfect for adding that little bit extra to the Revell kit. In particular, bronze undercarriage legs are superb and if you only buy one set, then this is the one to go for. The choice is yours in how far you want to go, they are all pretty easy to use, so you may want to make a fuss of the kit go for the lot.

 

Review sample courtesy of

logo.gif

  • Thanks 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...