Shar2 Posted July 26, 2015 Share Posted July 26, 2015 Seatbelt and Mask sets for Revell Fw-190 1:32 HGW Each of these two sets are for the new 1:32 Fw-190F8 from Revell. The smaller of the sets contains just the seatbelts, whilst the large contains the seatbelts and a set of masks for the canopy, on in this case canopies, as there is a choice of two within the kit. This will probably be the most popular set.The laser cut belts are remarkably beautifully cut, with no ragged edges to worry about. Being laser cut, you are left with just a small join between the belts and the fret. With each part removed, it’s just a matter of threading through the etched parts and gluing the joints over. The belts are ready to fit, complete with markings and placards, to the seat and cockpit and there is a nice clear diagram showing the positioning, although you may wish to refer to actual photographs to get the correct level of sag. The masks also appear to be laser cut and there appears to be a little bit of shrinkage, which hopefully has been taken into account with regards to fit and coverage. The instructions clearly show which masks go where and for which canopy. Unlike most over mask sets HGW have included masks for both the interior and exterior making it a whole lot easier to airbrush the appropriate colours. ConclusionHGW have released two very useful sets although I imagine that the mask set will be the most popular. That said, it’s always good to have a choice and for those modeller who either don’t like or don’t need masks then they can just use the super seatbelts. Very highly recommended. Review samples courtesy of Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now