Search the Community
Showing results for tags 'You what?'.
-
Hello everyone! I have just finished having great fun over in the Group Build section of our lovely BM, where there are many gallant folks building a selection of aircraft that float and fly, seaplanes, flying boats, float planes Eraknoplans etc, and this is one what I did (sic)! The build log is here The kit was a basic Scaleplanes 1/72 Vacform that I picked up for £3 at my local model show a few years ago, Moulding were pretty crisp and fitted well, especially the top and lower halves of the main float - in fact I have had injection moulded parts that failed to click together better than these two bits! I added some detail in the cockpit, but as usual it is almost impossible to see. I had better luck with the engine - that was an interesting looking blob on the sheet, so I wondered whether to but a Small Stuff resin engine or scratch one, I did the latter in the end. In fact the engine ended up with something like 30 bits of plastic and copper wire, but was well worth doing, and added to my scratch build armoury. I also built the fuel tank, this time the kit parts were good, but I just felt like doing my own. I wrapped Aizu tape round for the strengthening straps and coated them in thin CA to seal them. Rigging was a mix of EZ-Line and a couple of types of speaker cable core pulled taut between two pairs of tweezers to get the wire straight. I tried to accent the rib tapes on the wings despite only using a paint brush for the colour scheme, and I think there is still practice required. Anyway, here it is, but please accept my apologies for the tattieness of the rigging exit points on the wings - this model was really fragile, and I was rather scared of holding it too hard when trying to clean them up as the struts were just butt-joined to the wings! Thanks for looking, all the best, Ray