Search the Community
Showing results for tags 'Revell1:32'.
-
Hi all, Been working on Revell's new Spitfire over on Large Scale Planes and it's suddenly dawned on me it might be of interest over here. OK - before I wade in - I won't pretend this is in any way definitive - it will include some mods I'll make following reference to photos/drawings/published dimensions/other kits - but my aim is to make a nice looking Spitfire - something I think easily achievable with this kit. What's more - it cost me the princely sum of £18 and I'd hate to waste it! For anyone that followed my He219 build I'd like to keep this thread on a similar - and positive - note throughout. Please chip in if you spot anything - and feel free to throw in discussion points. So - before I start... Kit fuselage: Top Hasegawa, middle new Revell, bottom Tamiya: Kit with Hasegawa Vb/Revell Hasegawa IIa fuselage (note difference in length from firewall (almost line-up perfectly - to front of cowl - don't ask which is right just yet): Hasegawa Vb/Revell Hasegawa IIa and Tamiya fuselage: Tamiya and Revell IIa fuselage: Comparison has already been made between the Tamiya kit and the new Revell one in Jen's excellent post on LSP, along with Derek Bradshaw's ongoing appraisal - nothing further to add. Interesting to note that the nose is quite a lot longer than the Hasegawa Vb - more investigation needed - but otherwise it matches quite closely in profile - if not cross section. Right oh - now to start... One of the first things I spotted were the fuselage sides - around the cockpit - appear to bulge out a little when viewed from above (or finger run along the sides) - and will need sanding back. Area is marked in red on photos - but actually are that needs modding extends further towards the firewall too. Likewise there is additional material on the wing roots that could do with removing - again as marked below. Not sure if I'll need to pack the area behind to prevent sanding all the way through - we'll see: And this is the relevant area inside the fuselage - not spotted before - but not conducive to getting the outer shapes right: Port side wing root in progress... Using the power tool and round grinding bit to remove most of the excess plastic: Before wading in with 280/400/600/1200 grit wet and dry wrapped around a pen: Looking better - still a little more to go methinks - but looks like there's enough 'meat' there to avoid any backfilling (modified left - kit right): Total time so far - about 20 mins. Back soon... Iain
- 103 replies
-
- 3
-
- Revell1:32
- Spitfire
-
(and 2 more)
Tagged with: