Search the Community
Showing results for tags 'OMG STAR WARS!!!'.
Found 1 result
Hi all, I thought it was time I tried some of these Bandai Star Wars kits I hear all the kids are going mad for... I'm not sure I'll have much to add to Andy and Adam's efforts, but I'd like to move some of the Star Wars-ey plastic from my stash to the cabinet where I can see it I started by putting the little ISD together, which was a pleasant experience. There are some fiddly seams in the superstructure and I'm not delighted with the fit of the bridge tower, but with some clothes pins and thin glue it seems to have mostly closed up. I managed to get glue to squeeze out of most of the superstructure joins so I could pare it down and sand it, but I haven't tried as hard with the joins on the vertical surfaces. I'm trying to decide whether to rip off Andy's "aztec" panelled finish or not - the movie ships are quite flat looking, after all. If I do try the panels, I might keep them to the recesses rather than the raised stuff, really not sure yet. Perhaps more interestingly, I've built up the contents of the 1/144 U-Wing box. The U-wing itself is in a variety of bits as I need to paint the interior, but the TIE Striker and Occupier tanks can be pretty much fully assembled before paint: Fit on both is the usual mix of perfection and not-quite-perfection - you can see some seams where the end-caps of the TIE Striker cabin attach, for example. I thought about running some CA into them, but I'm wary of cracking the plastic or indeed making a mess of what's currently a very sharp line. The same line appears on the 1/72 so presumably it's a legit panel line? The tanks fit pretty well and the seams are such that you *could* fill them all but maybe don't have to? And the U-Wing seems great from what I can see. There's a join right through the radiator fins at the back, so I opted to assemble these around the rear plates first and clean up the join. That means I'll need to make around it to paint the rest. I'd hoped that I could cut away enough of the pins that I could join the pieces and slide them into place, but some of the interlocking stuff is visible so I gave up. I'll put some more pictures up when it's in primer, as well as finish that Zoid Cheers, Will